How to install
Takes about 2 minutes. Anyone can do it.
- Clean the spot.
Wipe the glass or surface with a clean cloth. Let it dry. Dust and oil stop the decal from sticking. - Pick your spot.
Hold the decal up to check it. Use a little tape on the top edge to hold it in place. - Peel the backing.
Your decal comes on clear transfer tape. Peel the white paper backing off slowly. The decal should stay on the clear tape. - Stick it down.
Place it on the surface. Press from the middle out with a card or your fingers so there are no bubbles. - Peel the clear tape.
Pull the clear tape back slowly, at a low angle. If a piece lifts, lay the tape down, press again, and peel slower.
Best on smooth surfaces like car windows, laptops, and hard plastic. Apply at room temperature if you can.
Good to know
- Premium permanent vinyl in white or black. White is recommended and looks best on dark windows. It lasts a long time and only comes off with a razor blade or by picking at it.
- Wait a day before washing the car.
- Do not put it on a rough or dirty surface.
Watch a real install below.
Shop designsWatch it go on
A real application of the Nobody Is Coming To Save You decal.
See this decal